This heater has the hose connections on the rear for convenient mounting to the firewall or any panel. This helps to avoid exposed hoses on the interior as well as simplify installation. Air enters from rear; warm air exits through front through a louver that can be directed to where heat is desired. The fan uses a 2-speed motor. This is an excellent choice for heating a forklift, telehandler, or any other piece of equipment with a cab.These heaters need a coolant line to be hooked up to the heater. Heat provided through this liquid coolant has higher heat output and are very efficient compared to all electric heaters.Case Material: Steel Fan: 2-Speed Heating BTU/HR: 20,000 Power Requirements: 4A @ 24V Fittings: 5/8″ Height: 6-1/2″ Length: 9-1/2″ Depth: 7″Parts Included: (2) 5/8″ Heater Hose Y-Splicers (2) 5/8″ Rubber Grommets (8) Hose Clamps (4) Mounting Screws (1) Rocker Switch (1) Rocker Switch Mounting Panel (1) Inline FuseMounting hardware is (included), however, 5/8″ heater hose and 14 gauge wiring will be required to complete installation.
